0 of 25 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 25 Questions answered correctly
Your time:
Time has elapsed
There is no pass/fail on the day 1 quiz therefore no score will be displayed. You should be able to see the number of questions you answered correctly.
Where can you find helpful troubleshooting guide, videos, training and your submitted help forms?
When looking at the below model number of a User Interface, what would the “ITC” indicate?
All current communicating controllers are backwards compatible?
If a communicating controller fails, you can wire in a 24v thermostat and keep all of the same equipment functionality?
If you have a controller that is set to 70° and the controller is reading 70°, what could the actual temperature of the space be?
What is the current software version for -B or greater controllers?
What is the easiest/quickest way to update the wall controller?
The controller can allow the system to overcool by up to 3° as long as the temperature is above 65° inside ?
To unlock a locked screen controller you must?
If a user cannot see their controller within the app or their online account, which remote access status could indicate a problem?
What will be required for Remote Access Setup when registering an account?
Comfort profiles can be set for each programmed period?
What is 1 thing you MUST do if connecting the controller to WiFi?
What setting could enable a system to run inadvertently while following a schedule?
If the Occupancy Status indicator is Gray, what would this tell us?
Do you have to hold the Service Hat until it turns green to get into the Homeowners Advanced Screen?
If you are installing a controller in a closet and wiring in a remote sensor you MUST enable humidity for remote sensing?
Remote room sensors use what type of resistor?
How many remote room sensors must you use in order to temperature averaging?
How do you wire your 4 remote sensors for temperature averaging?
When should you use 18 AWG thermostat wire?
In what scenario might you need a NIM (Network Interface Module)?
On power up, what is the 1st piece of equipment the controller identifies?
Smart Recovery will start recovery ____ minutes prior to schedule change in both heating and cooling mode
The “Heat Source” menu from the Homeowner Menu Screen will allow the user to set the heat source, much like an “emergency heat” selections?