0 of 40 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 40 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
One of the best ways to get information on Carrier & Bryant equipment is to _____________________.
On the the Carrier/Bryant Mobile App what features are available?
What is the most unique feature added to the Infinity® 26/24 with Greenspeed  Intelligence & Evolution™ Extreme 26/24 systems?
Where is it recommended to install the filter/drier on the 4 ton unit and smaller?
What terminals are required to be hooked up for proper operation in a communicating system?
What is the purpose of the Braze Plate Heat Exchanger in the 5 ton machines?
What is the most unique feature added to the Infinity® 26/24 with Greenspeed  Intelligence & Evolution™ Extreme 26/24 systems?
What does the PCM sense to control the EXV in heating mode?
The green LED on the PCM board indicates what?
When does the ECM fan motor NOT operate?
A flashing amber LED on the PCM board indicates what?
All 26/24 SEER Greenspeed/Extreme units have a Braze Plate Heat Exchanger and an EXV?
The PCM board was formerly know as the ____________ board?
The PCM board has _____ fuse/s?
With the Bluetooth module you can_______________?
The crankcase heater is energized when the outdoor temperature drops below __________°?
These units use a 5vdc output discharge and suction pressure transducer, what is the vdc range expected to be seen?
What version of software MUST the UI be updated to?
What is the MAX. outdoor ambient temperature for cooling mode?
What is the MAX outdoor ambient temperature for heating mode?
What is the maximum equivalent length of lineset allowed on 26/24 SEER Greenspeed Units?
Where is it recommended to install the filter/drier on the 5 ton unit?
What does the solid red LED indicate?
What is the maximum equivalent line length for the 5-stage unit?
What is the fastest way to update the UI software?
What voltage should you measure when checking on the “A” to “B” terminals when power is applied and a User Interface is connected?
How many steps does it take for the stepper motor on the EXV to go from fully open to fully closed?
What is the Bluetooth signal range?
What position is the EXV in during cooling mode?
What is the correct answer using the formula below when testing a transducer? Your measured output vdc on white and black is 2.5vdc
Suction Pressure psig = 50.0 x (DCV out – 0.5)
Which of the following is not a method to provide updates?
At what range of RPM’s does the ECM motor operate at?
How many components are updatable in a 26/24 SEER Greenspeed/Extreme system?
What is the default defrost interval set at?
Which thermistor is NOT a 10k NTC resistor in Inverter driven units?
What voltage should you measure when checking on the “A” to “B” terminals when power is applied and NO User Interface is connected?
What is the method to recall fault codes when there are no fault code present at your time of service?
How do you read the active fault codes using the status LED on the control boards?
When checking a transducer that has power while connected to the ODU board and power is applied, what color wires would you check for your voltage output?
At what pressure does the High Pressure Switch open at?